Convert an Old Bike into an Electric Motor Bicycle

April 14th, 2011 |

Author: admin

Electric bicycles are becoming more popular these days. And with the high prices of fuel, worsening pollution and increasing traffic congestion, many are starting to opt for better transportation that can take them to different places. Most of them like something that is very convenient, at the same time something that will allow them to save some cash. And these are exactly what an electric bicycle does.

But what’s even more exciting about electric bicycles is how easy one can own them. Buying them is definitely cheaper than buying a new car or a traditional motorcycle. However, if you can build one, you can definitely save more money. And building an electric bike is super easy. You just have to start with an old bike and an electric bicycle motor conversion. And by following this simple guide, you will definitely be riding your own eBike in no time.

1. To start, you need to find out if your bike is the type that can be converted into an electric bicycle. You can refer to your conversion kit manual to find out if you can really turn your old bike into an eBike. You also need to make sure if your electric motor properly fits your bike.

2. After that, you need to strip down the bike of all its unnecessary accessories. Basically, you need to bring it down to its bare minimum.

3. You then need to remove the front wheel of the bike. Do this by turning the bike upside down, then releasing all the air from the tire. You then have to unscrew the axle nuts of the wheel to completely remove it from the frame. When doing this, be extra careful as to not damage the brakes.

4. Once the wheel is removed, you now have to install the new front wheel that comes with the conversion kit. This new front wheel have wires attach to the that will connect to the battery pack of the motor. You need to properly place the wheel so the wires will not be on the way. To learn how to properly do this, you can always refer to the manual. It will tell you which side to of the bike the wires need to exit from. This is because some conversion kits have them on the left, while some are on the right. After figuring this out, you then have to secure the wheel properly by tightening the axle bolts by using a wrench. If necessary, adjust the brake so they work properly.

5. Then, you have to mount the battery pack to the bike. The place where you should put them may vary depending on the model type of the conversion kit you have. However, most battery packs for electric bicycle motor kits use the rear axle and seat clamp as support.

6. Once the battery pack is in place, you now have to mount the controllers. Though there are some variations on this part of the kit, they usually go below the handlebars or under the seat rack. Use zip ties or bungee cables to install the controller properly.

7. Next, install the throttle. Do this by removing the right handlebar grip. All you need to do is to slide the throttle over the handlebar and using a wrench, tighten them in place.

8. After that, you now need to run the wires and connect them to the motor and controllers. You shouls also connect them to the throttle. Refer to the manual to ensure that all wirings are on their proper places. Tame the wires using zip ties so they are not in the way for when you are riding the bike. Finally, you can connect the wires to the batteries to complete the circuit.

9. Test the ignition to ensure that everything is in their proper places. If you follow all the steps properly, you will start riding your electric bike in no time.

To learn more about electric bicycle motors and their many different benefits, visit http://electricbicyclemotors.org today!

Convert an Old Bike into an Electric Motor Bicycle

Share